SMA BLUETOOTH REPEATER OUTDOOR - Manual (Page 23)

SMA Solar Technology AG 7 Settings
Installation Manual BTREPOUT-IA-en-11 23
7 Settings
7.1 Setting the MODE
The MODE rotary switch is set to the position 0 for delivery. Other positions are not permitted and
are intended for SMA Service only.
• If the MODE rotary switch is not positioned
correctly, set the correct position:
– Remove the seal insert of the screw seal from the
top of the Bluetooth Repeater Outdoor using a
screwdriver (2.5 mm). Thus you can see the
MODE rotary switch in the inside of the
enclosure and reach it using the screwdriver
(2.5 mm).
– Turn the arrow of the MODE rotary switch to the correct position using a screwdriver
(2.5 mm).
– Insert the seal insert of the screw seal and tighten it using a screwdriver (2.5 mm). This
ensures the degree of protection IP54.
7.2 Setting the NetID
The NetID serves to distinguish PV plants with SMA Bluetooth operating in close proximity to one
another. All devices in a PV plant must have the same NetID. You can set the SMA Bluetooth Repeater
Outdoor to the NetID of your plant using the "NetID" rotary switch.
Assignment of the rotary switch positions*
* See Section 10.2 for information on the status of the Bluetooth LEDs.
NetID Function
0 Bluetooth is switched off.
1
(Default setting) Bluetooth is switched on.
The device can connect to a maximum of two communication products. The
device cannot connect to other inverters or SMA Bluetooth Repeaters.
2 ... 9 and A ... F Bluetooth is switched on.
The device can interlink with all SMA Bluetooth products with the same
NetID.