SMA BLUETOOTH REPEATER OUTDOOR User Manual
Page 22
![background image](/files/818689/content/doc022.png)
6 Electrical Connection
SMA Solar Technology AG
22
BTREPOUT-IA-en-11
Installation Manual
4. Insert the cable into the enclosure through the nut
and the cable gland.
5. Connecting the cable to the feed-through terminal
in the inside of the enclosure:
– Push the terminal 1 and terminal 2 of the
feed-through terminal open using a screwdriver
(2.5 mm).
– Connect the wires of the cable to terminal 1 and
terminal 2. The polarity is arbitrary.
6. Recommission the inverter with installed Power
Module (see inverter manual).
☑ LED RDY is glowing green.
✖ The LED RDY is off or flashing?
• Rectify the fault (see Section 10.1 "Voltage Supply", page 27).
7. Check that the cable gland seal is correctly in
place. The seal must not protrude over the cable
gland.
8. Hand-tighten the nut to the cable gland. Tighten the nut with a torque of 0.8 Nm thus securing
the cable.
9. Reattach the enclosure lid using the enclosure lid screws.