SMA BLUETOOTH REPEATER OUTDOOR - Manual (Page 26)

9 Decommissioning SMA Solar Technology AG
26 BTREPOUT-IA-en-11 Installation Manual
9 Decommissioning
9.1 Detaching the Bluetooth Repeater From The Wall.
1. When connecting to the AC grid separate the Bluetooth Repeater Outdoor from the voltage
supply using the separator and check that there is no voltage present in the cable. When a grid
connection plug is used remove it from the socket-outlet.
2. Remove the cable gland of the Power Module for the connection to the Power Module
(see installation manual of the Power Module).
3. Loosen the screws of the enclosure lid and remove the lid.
4. Remove the screws of the enclosure from the wall and take down the Bluetooth Repeater
Outdoor.
5. Remove the cable from the feed-through terminal in the inside of the enclosure.
– Push open terminal 1 and terminal 2 of the feed-through terminal using a screwdriver
(2.5 mm)
– Pull out the wires of the cable.
– Remove the cable from the enclosure. To do this, unscrew the nut from the lower left corner
of the cable gland of the enclosure and pull out the cable gland from the enclosure.
6. Reattach the enclosure lid using the enclosure lid screws.
9.2 Packing the Bluetooth Repeater Outdoor
• Pack the Bluetooth Repeater Outdoor using the original packaging or packaging that is suitable
for the weight and size of the Bluetooth Repeater Outdoor (see Section 11 "Technical Data",
page 32).
9.3 Disposing of the SMA Bluetooth Repeater
• Dispose of the Bluetooth Repeater Outdoor in accordance with the locally applicable disposal
regulations for electronic waste.
or
Send the Bluetooth Repeater Outdoor back to SMA Solar Technology AG with shipping paid
by sender. When doing so, label the packaging "ZUR ENTSORGUNG" ("FOR DISPOSAL").