SMA BLUETOOTH REPEATER OUTDOOR - Manual (Page 21)

SMA Solar Technology AG 6 Electrical Connection
Installation Manual BTREPOUT-IA-en-11 21
9. Check whether the cable gland seal is correctly in
place. The seal must not protrude over the cable
gland.
10. Hand-tighten the nut to the cable gland. Tighten the nut with a torque of 0.8 Nm thus securing
the cable.
11. Reattach the enclosure lid using the enclosure lid screws.
6.2 Connecting the Bluetooth Repeater Outdoor to the Voltage
Supply
Requirement:
☐ The Power Module is installed in the inverter (see Power Module installation manual).
1. Loosen the enclosure lid screws and remove the enclosure lid from the
Bluetooth Repeater Outdoor.
2. Unscrew the nut from the lower left corner of the cable gland of the enclosure and push the
filler-plug out of the nut.
3. Preparing the cable:
– Remove 40 mm of the cable sheath from the
side of the Bluetooth Repeater Outdoor.
– Shorten unused insulated wires flush with the
cable sheath.
– Strip approx. 10 mm off the wires.
Danger to life due to electric shock when opening the inverter
Lethal voltages are present in the conductive parts of the inverter.
• Prior to performing any work on the inverter, disconnect the inverter from any voltage sources
on the AC and DC sides (see inverter installation manual). Observe the waiting time to allow
the capacitors to discharge.