Yaskawa G5 Electronic Lineshaft Alignment - Manual (Page 15)

Electronic Lineshaft with Alignment
Date: 07-01-04, Rev: 04-07 Page 15 of 15 TM.G5SW.046
6.0 New Alarm and Fault Codes
Alarm Display Name Description Corrective Action
FOL_ALM
Following Alarm
Following Alarm
The position error between
the master and slave
exceeded the allowable
amount. (P1-07 – P1-08)
Check for physical obstruction of
slave motion.
Fault Display Name Description Corrective Action
FOL_FLT
Following Fault
Following Error
The position error between
the master and slave
exceeded the allowable
amount. (P1-07 – P1-08)
Check for physical obstruction of
slave motion.
Fault Display Name Description Corrective Action
ALIGN_FLT
Align Fault
Alignment Error
The error count between
the master and slave
exceeded the allowable
amount. (P1-03)
Check the trigger input switches.