Yaskawa SI-W3 - Manual (Page 30)

7 Network Variables
30 YASKAWA ELECTRIC TOBP C730600 56A 1000-Series Option SI-W3 Installation Guide
■ Object Status
Output: FSNVT_obj_status nvoStatus
Displays the status of objects in a node.
Member Name Description
object_id Object ID (refer to the object request)
bit 31 invalid_id Turns ON if the object_id specified by nviRequest is invalid.
bit 30 invalid_request Turns ON if the object_request specified by nviRequest is invalid.
bit 29 disabled
Indicates whether or not a given object is enabled for operation.
Turns ON when an object is disabled.
bit 28 out_of_limits Not supported. (Always 0.)
bit 27 open_circuit Not supported. (Always 0.)
bit 26 out_of_service Not supported. (Always 0.)
bit 25 mechanical_fault Not supported. (Always 0.)
bit 24 feedback_failure Not supported. (Always 0.)
bit 23 over_range Not supported. (Always 0.)
bit 22 under_range Not supported. (Always 0.)
bit 21 electrical_fault Not supported. (Always 0.)
bit 20 unable_to_measure Not supported. (Always 0.)
bit 19 comm_failure Not supported. (Always 0.)
bit 18 fail_self_test Not supported. (Always 0.)
bit 17 self_test_in_progress Not supported. (Always 0.)
bit 16 locked_out Not supported. (Always 0.)
bit 15 manual_control Not supported. (Always 0.)
bit 14 in_alarm Not supported. (Always 0.)
bit 13 in_override Not supported. (Always 0.)
bit 12 report_mask Not supported. (Always 0.)
bit 11 programming_mode Not supported. (Always 0.)
bit 10 programming_fail Not supported. (Always 0.)
bit 9 alarm_notify_disabled Not supported. (Always 0.)
bit 8 to 0 reserved Always 0.
TOBP_C730600_56A_0_0_E.fm 30 ページ ２０１１年１１月２日 水曜日 午後６時１０分