3 receiving, Option package contents, Tools required for installation – Yaskawa SI-W3 User Manual
Page 9: 3receiving
YASKAWA ELECTRIC TOBP C730600 56A 1000-Series Option SI-W3 Installation Guide
9
3 Receiving
3
Receiving
Please perform the following tasks upon receiving the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears
damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the option
nameplate
(Refer to
on page
for more information).
• Contact your supplier if you have received the wrong model or the option does not
function properly.
◆
Option Package Contents
◆
Tools Required for Installation
• A Phillips screwdriver (M3 metric / #1, #2 U.S. standard size) is required to install the
option.
• A straight-edge screwdriver (blade depth: 0.4 mm, width: 2.5 mm) is required to wire the
option terminal block.
Note:
Tools required to prepare option cables for wiring are not listed in this manual.
Descri
ption:
Option
Ground
Wire
Screws
(M3)
LED Label
Bar Code
Installation
Manual
_
Quant
ity:
1
1
3
1
1
1
ERR
RUN
RX
TX
*123456789ABC*
*123456789ABC*
*123456789ABC*
MANUAL
TOBP_C730600_56A_0_0_E.fm 9 ページ ２０１１年１１月２日 水曜日 午後６時１０分