Irritrol Total Control-R Series - Manual (Page 18)

16
MANUAL OPERATIONS
Manual operation allows you to run individual stations or start
automatic watering programs as needed. The Total Control provides
separate dial positions for each type of operation: Single Station and
Program Cycle.
SINGLE STATION
This option enables individual stations to be operated for an untimed
duration (turned On/Off) or operated for a selectable duration from
one minute to 10 hours.
1. Turn the function dial to the Single Station position.
2. Select Program A , B , C or D with the Program switch.
Note: The programmed status of the master valve/pump start in
the selected program determines whether the master valve/pump
start will be activated with the manual operation
.
3. Use one of the following options to operate the station.
For untimed operation:
A . Press the NEXT button as necessary to display the station you
wish to operate.
B . Press the ON button. The station will turn on and remain on
until one of the following occurs:
•The
OFF button is pressed
•The controller clock passes midnight
•The function dial is moved to another position
For timed operation:
A . Press the NEXT button as necessary to display a station you
wish to operate.
B . Use the + and/or – buttons to set the desired amount of station
run time (for this operation only), from one minute to 10 hours.
C . To select additional stations to operate in sequence, repeat steps
A and B as desired. Each station will operate one-by-one in the
order they were selected.
D . Leave the function dial in the Single Station position until the
manual operation is complete, then return the dial to the
Run position.
Operating the Controller