iSys i24 Direct Imaging Printer User Manual
Page 14
i24 USERS GUIDE - 3.31.2005
13
Range:
0...999
NOTE:
Adjustments are in 1/16 of an inch increments.
Hyst.
Used to adjust image quality at higher speeds. This setting looks at the
history of each dot and decides through an algorithm the amount of energy needed.
Default “Off”.
Range: Off, 1...5 (darkest)
NOTE:
This setting can make the fill patterns look lighter or darker.
EOT Cut
Automatically cuts the media when an EOT command is received from
the host. This setting will advance the media past the cutter then cut the
media off.
Default “No”.
Setting: Yes or No
Pre-buff
Helps hosts with slower data transfer rates to plot using a faster speed
without the stop and start gaps. This setting uses the onboard memory to
buffer the incoming data before plotting the image. Default “Off”.
Setting: On or Off
NOTE:
Memory can be expanded up to 32 Meg.
Nib save
Helps nib life on vertical boarders that are always turned on.
Default “Auto”.
Settings:
Auto
(automatically shifts plot left and right)
Lock@1
(lock image in position)
Lock@2
Lock@3
Lock@4
Lock@5
Center
(center image)
NOTE:
Auto setting is recommended to help improve nib life. If the print head is
missing a nib the plot can be shifted and locked in place using the Lock@ setting.