Lanner FW-8895 - Manual (Page 12)

8
Introduction
Chapter 2
Network Application Platforms
Note:
1. If you have only one CPU, install it on the left
side (CPU socket No.1with the front panel
facing you). Failure to do so will result in boot
failure .
2. To protect the CPU socket pins, retain the CPU
cap when the CPU is not installed.
6
Installing the Hard Disk
For models FW-8895A and FW-8895B, the system support
two internal HDD installation. However, it requires that
the top compartment to be unmounted.
To unmount the top compartment, follow these steps:
1. Take off the back cover by unscrewing two
thumbscrews on the back. Disconnecting any
cables that connect to the connectors of the top
compartment.
2. To take out the top compartment, unscrew 3 screws
from both sides and one screw on the bottom of the
compartment.
3. Lift the compartment to unmount it from the system.
unscrew the thumbscrews on
the back and open the back
cover.
Take out the first expansion
module in the front slot and
unscrew the screw on the bot-
tom of the compartment
Lift the front compartment to
unmount it from the system
Hard disk mounting location