Lanner LEC-2280 - Manual (Page 22)

22
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Note: To remove the SIM card, slide the card
reader outward to unlock it.
PCI/PCIe Riser Card Installation
The system can accommodate one PCIe expansion (or two
PCI expansion on model P2) module. In order the install
the PCIe expansion module, a low-profile riser card has
to be installed first. Follow these steps to install the riser
card:
Fix the riser card on the bracket with 3 screws. 1.
Install the riser card to the system by connecting the 2.
connectors with the system’s PCIEIO1 connector.
Fix the riser card on the board.
3.
Connect the PCIe expansion card to the riser. 4.
Fix the card holder back to the system. 5.
On 2280E with one PCIe slot
Wireless Module Installation
Align the wireless module’s cutout with the Mini-PCIe 1.
slot notch.
Insert the wireless module into the connector
2.
diagonally.
Hold down the other end of the wireless module and
3.
tighten it with the screws.
3G SIM Card Installation
Unlink the SIM card reader first by sliding it outward. 1.
Flip the SIM card reader diagonally. 2.
Align the cut corner of the SIM card pointing toward 3.
SIM card reader. Make sure the ICs will be in contact
with the SIM card reader.
Insert the
4. SIM card into the reader and close the tray.
You should feel a click when the SIM card is locked
securely in the SIM card reader.
Lock
Unlock
1
2
3
2
3
4
2
3