Lanner LEC-2280 - Manual (Page 9)

9
System Components
Chapter 2
Embedded and Industrial Computing
Rear Components
Component Description Pin Definition Reference
R1 DC-In (power) 1x2 Pin
Phoenix Contact Connector
Power-in Connector. The LEC-2280
support power range between
+9~+30V DC-in.
CN4 on page 19
R2 Two USB 2.0 Ports An USB type A connector. In addition to
this connector, an internal pin header is
also provided..
USB3 Connector on Page 17
R3 Two 10/100/1000Mbps LAN
ports
Two RJ-45 (network) jacks with LED
indicators as described below. The LAN
ports are provided by Intel 82574L.
They both support WOL/Remote-
wake-up/PXE function.
LINK/ACT (Yellow)
On/Flashing: The port is linking •
and active in data transmission.
Off: The port is not linking.
•
SPEED (Green/Amber)
Amber: The connection speed is •
1000Mbps.
Green: The connection speed is
•
100Mbps
Off: .The connection speed is
•
10Mbps.
LAN1/LAN2 on page 20
R4 DVI-D A DVI-D port (single link) which is
provided by Intel HD Graphic Engine.
This port can support up to 1920x1200
@ 60 Hz resolution.
DVID1 Connectors on page 18
R5 HDMI A HDMI (High-Definition Multimedia
Interface).This port can support up to
1920x1200 @ 60 Hz resolution.
HDMI1 on page 18
R6 VGA Port(†) The displays can support VGA up to
2048x1536 resolution.
VGA1 on page 18
R7 MIC IN/LINE OUT(†) Connect the audio devices to these
ports. The Microphone and line out
port are provided by Realtek ALC
ALC886.
CN1, CN2 on page 15
F8 Serial Ports Serial ports through the DB-9
connector; Both COM1 and COM2
support RS-232/422/485 with jumper
selection among RS-232/422/485.
COM1/COM2 on page 15
R9 Slot for PCIe expansion (*) The PCIe/PCI expansion capability
is accomplished via the riser card
connected to the system
PCIEIO1 Connector on page 18
†Note that the driver for these ports should be installed with the following order: Chipset INF->Graphic->Audio
* Model LEC-2280P2 can support 2 PCI expansion.
R9
R2 R6 R1
sPEEd LINK/ACT
R3 R5 R4
R7
R8