Empire Comfort Systems DVD36FP3 EN - Manual (Page 23)

23552-1-0607 Page 23
I nstalling Vent Components (Figure 36)
Begin the vent system installation by installing the first Simpson
Duravent component, 90° elbow to the starting collars or straight
pipe on the top of the appliance, then the straight pipe length and
then horizontal or vertical termination kit.
NOTE: All outer connection joints must be sealed with aluminum
tape, screws or silicone sealant rated above 300°F/149°C. The
inner flue joints do not require any sealant.
Simpson Duravent vent system components lock into place by
sliding the concentric pipe section with four (4) equally spaced
interior beads onto the appliance collar or previously installed
component end with four (4) equally spaced indented sections.
When the internal beads of each starting outer pipe line up, rotate
pipe section clockwise 90° (approximately 3 inches). The vent pipe
is now locked together.
Continue adding components per the pre-planned vent system
configuration. Be certain that each succeeding vent component
is securely fitted and locked into the preceding component in the
vent system.
Figure 36
WALL THIMBLE
(MAXIMUM OF
THREE 90 ELBOWS)
(MAXIMUM OF
TWO 90 ELBOWS)
Special Venting Components (Simpson Duravent)
See Empire Comfort Systems Retail Price List for Simpson Duravent part numbers
and pricing.
Special DV Vent Kits
Available from Empire Comfort Systems, Inc. dealers.
DVVK-4FV Vertical Flex Vent Kit 4" x 7"
DVVK-4V
Direct-Vent Fireplace Vent Kit - Vertical, Includes SD-991, SD-
953, and SD-943
DVVK-4T Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall, 8 to
11 inch wall thickness, Includes SD-911, SD-985, SD-990 and
SD-942
DVVK-4R Direct-Vent Fireplace Vent Kit for Rear Vent, 5 to 7 inch wall
thickness, (standard thru-the-wall venting) Includes SD-908, SD-
985 and SD-942
DVVK-4RE Direct-Vent Fireplace Vent Kit for Rear Vent, Thru-the-wall, 5 to
13 3/4 inch wall thickness
DVVK-4TS Direct-Vent Fireplace Vent Kit for Top Vent, Thru-the-wall, 5 to
7 inch wall thickness, Includes SD-908, SD-985, SD-990 and
SD-942
VIB6A Vertical Inlet Baffle Kit for 6 5/8" dia.
VIB7A Vertical Inlet Baffle Kit for 7" dia.
VENT SYSTEM IDENTIFICATION