Casio XJ-H2600 User Guide User Manual
Page 67
67
To control the projector using Network Projection Control
1.
Depending on the type of LAN connection you are using, perform either of the
following operations to display the top page of the projector’s System Admin
page.
2.
Click “System Admin”. On the password input screen that appears, enter the
password.
z The initial default password is “admin”.
3.
Click the [Login] button.
z This logs in to the System Admin page and displays the Status screen.
4.
Click “Control Panel” on the left side of the screen.
z This will display the Network Projection Control screen like the one shown below.
z The table below explains the status information and the projector operations included on the
Network Projection Control screen.
Wired LAN Connection
: “To establish a wired LAN connection between the projector and a
Wireless LAN Connection : Steps 1 and 2 under “To log in to the projector’s System Admin
page” of the “Wireless Function Guide”
Group
Item
Description
Refresh (Button)
Click to refresh the screen with the latest information.
Status
Projector status
Shows the projector’s current status as either “On” or “Standby”.
Error info
Shows one of the following.
Normal: Operating normally.
Temperature error: Temperature error occurred.
Fan error: Fan error occurred.
Light error: Light source unit error occurred.
Other error: Error other than above occurred.
Power On/Power
Off (Buttons)
Turn the projector on/off.
[Power On] button operation is supported only when the projector is
connected to a computer of a wired LAN connection, and “Enable” is
selected for the “Remote on” setting (pages 48).