Casio YA-D30 User Guide - Manual (Page 16)

16
7.
Click in the lower right corner of the Viewer window.
z This changes the Viewer window to the full-screen view. The projected images from the
connected computer will appear in 3D if you view them using 3D glasses (YA-G30).
z To return from the full-screen view to the window view, double-click anywhere on the screen.
Important!
To view an image in 3D while wearing the 3D glasses, make sure that you select the full screen
view of the viewer window. Viewing in 3D is not supported while the window view (even if the
window view is maximized) is displayed for the Viewer window.
8.
To close the Viewer window, click the button in the upper right corner.
z This returns to the CASIO 3D Converter window.
Note
z To remove a 3D file from the file list, close it by clicking the button on the far right of the
file’s information on the file list.
z You also could perform either of the following operations in place of step 2 of the above
procedure.
Or:
Clicking on the Viewer window displays the “3D Stereo Settings” dialog box, which you can use
to configure the settings described below.
1 If the playback file is a movie file, click “3D Video” under the device icon. If it is a still
image file, click “3D Image” under the device icon.
2 Drop the file you want to play back into the file list area of the CASIO 3D Converter window.
Or you could click to display the “Open” dialog box, select the file you want to play
back, and then click [Open].
1 If the playback file is a movie file, click the device icon. If it is a still image file, click the
device icon.
z A plus (+) mark will appear in a device icon whenever the mouse pointer is located above
it. Click when you see the plus mark.
2 Use the “Open” dialog box that appears to select the file you want to play back and then
click [Open].
3D File Playback Settings
Dialog Box Item Description
Auto detecting 3D files. Selecting the check box of this option configures the software to detect the 3D
file type automatically and then play back the file. If auto identify does not
produce the desired results, clear this check box, and specify the layout and
aspect ratio of your source file.
Which is the following layout of
your source file: Specifies the layout of the playback 3D file.
Which is the following aspect ratio
of your source file: Specifies the aspect ratio of the playback 3D file.
Swap Left/Right image when you
experience eyestrain in 3D mode Swaps the display timing of the left image and right image of the playback 3D
file.