Silvercrest SEKU 2000 A1 - Manual (Page 67)

66
Setting up and connecting
SEKU 2000 A1
GB
MT
Installation requirements
For the safe and correct operation of the appliance, the installation site must satisfy the following requirements:
The appliance must be placed on a fi rm, fl at and horizontal surface. ■
Do not place the appliance in a hot, wet or very humid environment or close to infl ammable materials. ■
The appliance may not be used directly adjacent to a bath-tub, shower or swimming pool. ■
The mains power socket must be easily accessible at all times, thus enabling the plug to be immediately ■
withdrawn should an emergency situation arise.
The appliance may not be located directly below a mains power socket. ■
Ambient temperature range: +5 to +45 °C ■
Humidity (No condensation): 5 - 90 % ■
DANGER
Fire hazard due to material contact!
If the heater makes contact with fl ammable materials, there is a risk of fi re!
Pay heed to the following safety information to avoid these fi re risks:
Keep infl ammable materials well away from the place of installation of the appliance. ►
Prevent the physical contact of combustible materials (e.g. textiles) with the appliance. ►
Do not cover the warm air outlet openings of the appliance. ►
Before the fi rst use
Remove all packaging materials and transport restraints from the appliance. ■
NOTICE
When you fi rst use it, it may temporarily generate a light odour. This is normal and completely harmless. ►
Electrical connection
For a safe and correct operation of the appliance, take note of the following instructions regarding the
electrical connection:
Before you connect the appliance, compare the connection data (voltage and frequency) on the plate ■
with that of your electricity supplier. This data must tally, in order to avoid damage to the appliance.
Ensure that the power cable is undamaged and that it is not placed over hot surfaces and/or sharp edges. ■
The connecting cable must not be taut. ■
Buch_66252_LB5.indb Abs3:66 08.06.2011 14:59:13 Uhr