Silvercrest SEKU 2000 A1 - Manual (Page 78)

77
Troubleshooting/Storage/Disposal
SEKU 2000 A1
GB
MT
Malfunction causes and remedies
The following table will help with localising and remedying minor malfunctions:
Defect Possible cause Solution
The fl ame replication does
not light up.
The appliance is not switched on. Switch the appliance on.
The plug is not inserted.
Insert the plug into the
mains power socket.
The mains power socket does
not supply voltage
Check the fuses
The bulbs are defect. Replace the defective bulbs.
The appliance does not heat.
Switch is not turned on.
Switch
2 is not turned on.
Switch 3 is not turned on.
Heating level control defective
Switch on.
Switch
2 on.
Switch 3 on.
Inform Customer Services.
The fan does not run.
Switch is not turned on.
Switch
2 is not turned on.
Fan defect.
Switch on.
Switch
2 on.
Inform Customer Services.
The heating is not switched off .
Thermostat 4 falsely adjusted.
Set the thermostat 4 at the
required temperature.
Temperature control 4 defect. Inform Customer Services.
NOTICE
If you cannot solve the problem with the aforementioned methods, please contact Customer Services. ►
Storage/Disposal
Storage
Disconnect the plug if you are not intending to use the appliance for a long period.
Store the appliance at a dry locality.
Disposal of the appliance
Do not dispose of the apliance in your normal domestic waste. This product is subject to
the provisions of European Directive 2002/96/EC-WEEE (Waste Electrical and Electronic
Equipment).
Dispose of the appliance through an approved disposal centre or at your community waste facility.
Observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre.
Buch_66252_LB5.indb Abs3:77 08.06.2011 14:59:17 Uhr