RISCO Group WatchOUT 315DT - Manual (Page 12)

12 WatchOUT 315DT Installation Manual
Technical Specification
Electrical
Current consumption
30mA at 12 VDC (Stand by)
42mA at 12 VDC (MAX with LED ON)
Voltage requirements 9 -16 VDC
Alarm contacts 24 VDC, 0.1A
AM contacts 24 VDC, 0.1A
Dust output Open collector 70mA max
Physical
Size: LxWxD
230 x 123 x 124mm (9 x 4.8 x 4.88 in.)
Weight 0.632 Kg (1.4lb)
Environmental
RF immunity
According to EN50130-4
Operating/Storage temperature -30°C to 60°C (-22°F to 140°F)
* PIR technology is limited in rough environmental conditions.
Ordering Information
Standard Units
Model Description
WatchOUT 315DT WatchOUT DT + Swivel
Note :
Each of the detectors contains a standard swivel and 3 replacement lenses (P/N engraved on the Lens) 1.7m
low installation pet (RL300F), long-range (RL300R) and barrier lens (RL300B).
Accessories Kits
Model Description Weight
RA300B WatchOUT Barrier Swivel Kit 0.1 Kg (0.23 lb)
RA300P WatchOUT Pole Adaptor Kit 0.25 Kg (0.55 lb)
RA300C WatchOUT Conduit Adaptor Kit 0.6 Kg (1.27 lb)
RA300HS WatchOUT Demo Housing - -
RA300SC WatchOUT Swivel Metal Conduit Adaptor 1Kg (2.2 lb)
Camera Option
Model Description
WatchOUT VC1 WatchOUT Camera Cover Adaptor
WatchOUT VC017 WatchOUT Narrow Camera
WatchOUT VC053 WatchOUT Wide Camera
WatchOUT VCPS WatchOUT Camera 220V Power Supply
WatchOUT VCPS WatchOUT Camera 120V Power Supply
UL Compliance Section
To comply with UL, note the following:
♦ The unit is intended for outdoor installation where unwanted alarms are tolerable. If not, it
is recommended to connect it to the trouble circuit of a listed compatible control unit.
♦ A dead zone of 5 ft should be considered during installation.
♦ The camera option is not UL listed.
♦ Disclaimer: PET feature has not been tested or verified by UL.
♦ 0.6 power factor inductive load can be used on the relays.
♦ Relay mode is intended to be connected to listed compatible control unit or power supply that provides 4
hours of standby power.
♦ It may be necessary to set detector at maximum sensitivity to achieve maximum distance.
♦ Do not connect the DUST output to a UL listed product.
♦ When the detectors are connected to the BUS of the ProSYS panel, the detectors are to be powered
from either the ProSYS (Version 7.55) panel or a listed compatible burglar alarm power supply that has
an output voltage range that does not exceed 9-16 vdc, has a minimum of 4 hrs. of standby power, and
is suitable for mercantile use.
Only P/N:
RK315DT00USB
is UL approved