EVGA force 132-YW-E178 - Manual (Page 24)

EVGA 14
8-pin ATX 12V Power ( PWR2 )
PWR2 , the 8-pin ATX 12V power connection, is used to provide power to the CPU. Align
the pins to the connector and press firmly until seated. This connector is notched, do not
force in.
Connecting IDE Hard Disk Drives
The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives.
1. Connect the blue connector (the cable end with a single connector) to the motherboard.
2. Connect the black connector (the cable with the two closely spaced black and gray
connectors) to the Ultra ATA master device.
3. Connect the gray connector to a slave device.
If you install two hard disk drives, you must configure the second drive as a slave device by
setting its jumper accordingly. Refer to the hard disk drive’s documentation for the jumper
settings.
If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are
attached to the same cable, the maximum transfer rate between the drives may be
reduced to that of the slowest drive.
GND 12V
1
8 4
5