EVGA force 132-YW-E178 - Manual (Page 30)

EVGA 20
Fan Connections
There are five fan connections on the motherboard. The fan speed can be detected and
viewed in the PC Health Status section of the CMOS Setup. The fans are automatically turned
off after the system enters S3, S4 and S5 mode.
Note that the CPU fan cable can
be either a 3-pin or a 4-pin
connector. Connect a 3-pin
connector to pins 1, 2, and 3 on
the motherboard connector.
CPU Fan Connector
4 3 2
1
GND SENSE
PWR CONTROL
EVGA nForce 780i SLI SPP/MCP fan connector
Install the fan over the nForce 780i SLI SPP
to draw heat from the MCP. The fan plugs
into a 3-pin connector.
Fan Connector
3 2
1
GND
+12V
SENSE