Amprobe DM-111S Current-Data-Logger - Manual (Page 42)

DMIIIS
EN - 40
10. CONNECTING THE INSTRUMENT TO A PC
In order to connect the instrument to a PC you must connect the serial cable shipped with
the instrument to the serial output.
NOTE: Any standard RS-232 cable will not work with the DM-IIIS.
The available transmission speeds are the following: 9600, 19200, 57600 (default value)
The value of the transmission speed (Baud Rate) is displayed on the initial screen
(immediately after turning on the instrument) (see paragraph 2.3). The value of this
parameter can be modified only with the management software.
For download instructions please refer to software help file.
In order to transfer the memorized data from the instrument to the PC the following
procedure must be followed:
1. Switch ON the instrument and wait until the Initial screen disappears.
2. Connect the serial output of the instrument to the serial output of the PC through
the serial cable.
3. Install the software and start it
– Close the introduction window.
4. Refer to software help file for further instructions.