Amprobe ACD-330T Clamp-On-Multimeter User Manual
Page 12
Advertising
Figure 6. Push Buttons
1. Press to select
DC or AC.
Press and hold for
more than 1 second
to toggle, between
PEAK and DC
or AC.
4. Press and hold
for more than
1 second to
set Dynamic
Recording then
press to step
through MAX,MIN,
AVG and present
reading.
5. Press to toggle the
Relative (ZERO)
mode ON/OFF.
6. In manual range
press to step up 1
range at a time.
Press and hold for 1
sec to select Auto
range
2. Press to toggle
Continuity(
•
)
)
)
)ON/OFF
for ohm measurement.
Press to set
frequency
measurements.
In V or A range.
3. Press to toggle
“DH” ON/OFF.
8
Advertising