Amprobe BAT-500 Battery-Impedance-Tester - Manual (Page 5)

BAT-500
Battery Impedance Tester
Keys And Input / Output Terminals
1 + POWER key : Power on / off
2 READ key :
1) Press key to show the manual logged readings.
2) Press READ key again to stop reading.
3 MEMORY key :
1) Under the manual logging mode, the tester stores each single set of
logged reading to the memory by pressing MEMORY key.
2) Press and hold MEMORY key for 2 seconds to enter continuous
logging mode. Press again to stop logging.
4 V-RANGE key : Select the voltage range. (4V, 40V)
5 HOLD key :
1) Press HOLD key to freeze or unfreeze the displayed reading.
2) Press and hold HOLD key for 2 seconds to enter the interval time setting
mode for continuous data logging.
6 Ω- RANGE key : Select the impedance range. (40mΩ, 400mΩ, 4Ω, 40Ω)
7 u REL key :
1) Press u key to move the cursor to the right.
2) Press REL (Relative) key to zero the reading.
8 p key : Press p key to increase the displayed value.
9 SET key :
1) Press SET key to switch the comparator mode on or off.
2) Press and hold the SET key for 2 seconds to enter the comparator-
setting mode. Press again to store the setting in memory.
10 q key : Press q key to decrease the displayed value.
11 t R Key :
1) Press t key to move the cursor to the left.
2) Press
R key to turn the beeper on or off.
12 RS-232 connector : PC interface connector.
13 – Input jack : For connecting with the black test lead plug.
14 + Input jack : For connecting with the red test lead plug.