Amprobe BAT-500 Battery-Impedance-Tester - Manual (Page 6)

BAT-500
Battery Impedance Tester
Display
1 The reading of the measured impedance (High or Low limit of impedance
on the comparator settings)
2 The reading of the measured voltage (High or Low limit of voltage on the
comparator settings)
3 The assigned number of comparator : 99 sets
4 The location for the manual logged data
mΩ The unit of impedance V The unit of voltage
HOLD Hold function Low-Battery Mark
The symbol of beeper COMP.SET Comparator settings
COMP The symbol will appear when the comparator function is ON
DATA The symbol will appear when the meter start manual
datalogging function or reading the manual logged data
DATA
Memory symbol for continuous datalogging function. The
symbol will flash when each data is stored to the memory.
INTV Interval time settings of continuous datalogging function.
(1~255 seconds)
HIGH High limit setting of the comparator impedance & voltage
LOW Low limit setting of the comparator impedance
1
2 3
4