Amprobe MEGATEST-5000 Megohmmeter - Manual (Page 26)

4.13 Use of the serial port
Connect the instrument to the serial port of your PC using the 9 pin RS 232 serial cable
provided.
In case your PC has a 25-pin connector simply use a standard 9 pin to 25 pin adapter (not
provided)
4.13.1 Reading and downloading the results of the measurements on a computer
If the “SUPERLINK” software has previously been installed, simply turn the instrument on
and start up the “SUPERLINK” Program on the computer.
To install the “SUPERLINK” software refer to the instructions on the floppy disk or CD.
Refer to the “Help” menu on the “SUPERLINK” for information on software use.
-24-