Amprobe DMII-PRO Data-Logger-Recorder - Manual (Page 31)

Page 31
To set voltage selection switch:
1. Disconnect the power cord from the power entry module.
2. Use a small screwdriver to open the fuse compartment door. Remove the drawer by pulling it out of
the power entry module.
3. Rotate the fuse holder so that the desired voltage setting is aligned with the window. Slide the fuse
holder back into the compartment until it snaps into place.
4. Snap the fuse compartment door back into place.
Fusing:
The fuse holder accepts the 0.25A@250V 1/4” 1/4” x 1-1/4” 5 x 20mm fuse.
WARNING: For continued protection against fire hazard, replace only with the same type and
rating of fuse as specified.