PLANET GSD-908HP - Manual (Page 11)

11
3. Installation
3.1 Desktop Installation
To install the PoE Ethernet Switch on desktop, simply follow the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE
Ethernet Switch, as shown in Figure 3-1.
GSD-908HP
PWR
PoE Usage 100%
ACT LNK
PoE In-Use
8 7 6 5 4 3 2 1
9- Uplink
Figure 3-1: Place the PoE Ethernet Switch on the Desktop
Step 2: Place the PoE Ethernet Switch on desktop near an AC power source.
Step 3: Keep enough ventilation space between the PoE Ethernet Switch and the
surrounding objects.
Note
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4 under Specifications.
Step 4: Connect your PoE Ethernet Switch to 802.3af / 802.3at complied Powered
Devices (PD) and other network devices.
A. Connect one end of a standard network cable to the 10/100/1000 RJ-45
ports on the front panel of the PoE Ethernet Switch.
B. Connect the other end of the cable to the network devices such as printer
servers, workstations, router, etc.
Note
Connection to the PoE Ethernet Switch requires UTP Category
6/5e/5 network cabling with RJ-45 tips. For more information,
please see the Cabling Specifications in Appendix A.