5 wiring the digital input / output – PLANET MGSW-24160F User Manual
Page 37
User’s Manual of MGSW-24160F
2.2.5 Wiring the Digital Input / Output
The 6-contact terminal block connector on the rear panel of MGSW-24160F is used for Digital Input and Digital Output. Please
follow the steps below to insert wire.
1.
MGSW-24160F offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups and 5 is GND (ground).The 6
pin is useless.
Figure 2-11
Wiring the Redundant Power Inputs
2.
Tighten the wire-clamp screws for preventing the wires from loosing.
1 2 3 4 5 6
DI0 DI1
DO0 DO1 GND N/A
Figure 2-12
6-Pin Terminal Block DI / DO Wiring Input
3.
There are two Digital Input groups for you to monitor two different devices. As following topology shows how to wire DI0
and DI1. We use MGSW-24160F to be an example for describing DI application.
37