PLANET WGSW-50040 - Manual (Page 12)

12
The following shows how to start up the Web Management of the Managed
Switch, please note the Managed Switch is configured through an Ethernet
connection, please make sure the manager PC must be set on the same IP
subnet address.
For example, the IP address of the Managed Switch is configured with
192.168.1.254, then the manager PC should be set at 192.168.1.x (where x
is a number between 1 and 253, except 254), and the default subnet mask is
255.255.255.0.
Login to the Web configuration interface. Valid login username and password are
required; otherwise the Managed Switch will reject Telnet access. This is a method
to protect the Managed Switch from unauthorized access. As a result, when
Telnet is enabled for configuring and managing the Managed Switch, username
and password for authorized Telnet users must be configured with the following
command:
web-user <username> [password (0|7) <password>]
Assume an authorized user in the Managed Switch has a username of “admin”,
and password of “admin”, the configuration procedure should like the following:
WGSW-50040> enable
WGSW-50040# config
WGSW-50040(config)# web-user admin password 0 admin
Enter valid login username and password in the web interface.