PLANET WGSW-50040 - Manual (Page 8)


6. Configure IP Address
The IP address configuration commands for VLAN1 interface are listed below.
Before in-band management, the Managed Switch must be configured with an
IP address by out-of-band management (i.e. Console mode), the configuration
commands are as follows (All switch configuration prompts are assumed to be
“WGSW-50040” hereafter if not otherwise specified):
WGSW-50040> enable
WGSW-50040# config
WGSW-50040(config)# interface vlan 1
WGSW-50040(Config-if-Vlan1)# ip address 192.168.1.254 255.255.255.0
The previous command would apply the follow settings for the Managed Switch.
IPv4 Address: 192.168.1.254
Subnet Mask: 255.255.255.0
Figure 6-1 Configure IPv4 address screen
To check the current IP address or modify a new IP address for the Managed
Switch, please use the procedures as follow: