PLANET XGS3-24040 - Manual (Page 12)

12
8. Start Web Management
For configuring the IP address on the Managed Switch through out-of-band
management, see the telnet management chapter.
To enable the Web configuration, users should type the CLI command IP http
server in the global mode as below:
XGS3-24040> enable
XGS3-24040# config
XGS3-24040(config)# ip http server
The Managed Switch provides a built-in browser interface. You can manage it
remotely by having a remote host with Web browser, such as Microsoft Internet
Explorer, Mozilla Firefox, Google Chrome or Apple Safari.
192.168.1.x
PC / Workstation
with
IE Browser
RJ-45/UTP-Cable
XGS3 Managed Switch
IP Address:
192.168.1.254
IP Address:
Figure 8-1 IP Management diagram
Note
Please refer to Chapter 5 – CONFIGURE IP ADDRESS for the
IPv4 IP address setting on the XGS3 Managed Switch.
The following shows how to start up the Web Management of the Managed
Switch, please note the Managed Switch is configured through an Ethernet
connection, please make sure the manager PC must be set on the same IP
subnet address.
For example, the IP address of the Managed Switch is configured with
192.168.1.254, then the manager PC should be set at 192.168.1.x (where x
is a number between 1 and 253, except 254), and the default subnet mask is
255.255.255.0.