PLANET ICA-310 - Manual (Page 13)

13
RJ-45 LAN Connector
For connect a LAN cable to your Hub/Switch.
The LAN port is a RJ-45 connector for connections to
10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This
Ethernet port built N-Way protocol can detect or negotiate
the transmission speed of the network automatically. Please
use Category 5 “straight” cable to connect the ICA-350 to a
100Mbps Fast Ethernet network switch or hub.
Note
In case you need to connect the device to PC or notebook directly,
you should use a cross-over cable instead.
Power Connector (for heater)
Connect to DC 12V power adapter.
Line in (audio in) *hardware version 2
Connect an audio input source to the ICA-350.
Line out (audio out) *hardware version 2
Connect a loud speaker to the ICA-350. This function is for
voice alerting and two-way audio.
5.3 Hardware Installation
1. Put the minor pad on ICA350 housing, fit into the mounting holes.
2. Attach the wall mount bracket onto the minor pad. Screw up with the 2pcs
screws with plastic washer. The wall mount bracket and ICA350 main body can
be isolated by plastic.
3. Fix ICA-350 to the location with wall mount fixture.
4. Plug-in Ethernet Cable into RJ-45 LAN port. Connect an Ethernet cable to the
LAN port on the ICA-350 and connect the other side of the Ethernet cable to a
hub/switch.
5. Connect the attached two power adapters to camera and plug-in this two
adapters into power outlet.
6. Connect Video BNC connector to a local TV monitor or DVR if necessary.
7. Done.