3 installation steps – PLANET ICA-310 User Manual
Page 7
 
12V DC-in Jack
The input power is 12V DC.
Note
Only use the power adapter supplied with IVS-110. Otherwise, the 
product may be damaged.
2.2.3 Installation Steps
1. Attach video source to IVS-110
 To use IVS-110, user must supply video source to IVS-110. Connect the BNC 
terminal of camera to the IVS-110’s video input and make sure to power on 
camera first.
2. Attach Audio source to IVS-110 (option)
 If user needs not only video stream but also audio stream, then the audio source 
should be attached to IVS-110. Connect the RCA terminal of audio device’s line 
output to the IVS-110’s RCA input and make sure to power on your camera or 
audio device first.
3. Plug an Ethernet cable into IVS-110
 Connect an Ethernet cable to the LAN socket located on the IVS-110’s panel 
and attach it to the network. If there has a PoE switch in your network, you can 
connect the IVS-110 LAN cable to this PoE switch to obtain power. The power 
adapter is unnecessary when IVS-110 is connected to a PoE switch.
4. Connect RS-485 (option)
 When users would like to apply a camera with P/T/Z function, they usually need 
to connect their communication port (for camera control) through RS-485. After 
RS-485 was correctly connected to D+ and D-, the remote users could control 
the camera movement through internet.
5. Connect the external power supply to IVS-110
 Plug in power adapter and connect to power source. If there has a PoE switch 
in your network, you can connect the IVS-110 LAN cable to this PoE switch to 
obtain power. The power adapter is unnecessary when IVS-110 is connected 
to a PoE switch. After power on, IVS-110 will start to operate. Once you have 
installed the IVS-110 well, the status LED will turn green. It means the system 
is booting up successfully. Furthermore, if you have a proper network connec-
tion, and access to the IVS-110, the LED will flash green.
6. Connect the power supply to one external camera (option)
 The IVS-110 can provide 12V DC out to supply one external camera. The output 
current is 400mA maximum.