PLANET VIP-156PE - Manual (Page 58)

STEP 7:
After enabling the auto-config feature, the ATA shall be able to obtain IP address and SIP
extension information from IP PBX system IPX-2000 information. To verify the auto-config
results, you may connect telephone set to ATA; press #120# to check if the IP address is
obtained from IPX-2000. And #122# can be used to verify the extension number assigned by
IPX-2000.
STEP 8:
Repeat the same configuration steps on ATA B, and check if the ATA B is successfully
registered with the IPX-2000 as one of the IP extensions.
Test the scenario:
1. Pick up the telephone on ATA A
2. Press the keypad: 2002 shall be able to connect to the ATA B
3. Then the telephone set in ATA B should ring. Please repeat the same dialing steps on ATA B to
establish the first voice communication from ATA A
58