PLANET IGT-1205AT - Manual (Page 25)

25
Connecting the fiber cable
1. Attach the duplex LC connector on the network cable to the SFP
transceiver.
2. Connect the other end of the cable to a device, switches with SFP
installed, to fiber NIC on a workstation or a Media Converter.
3. Check the LNK/ACT LED of the SFP slot of the switch / converter.
Make sure that the SFP transceiver is operating correctly.
 Removing the Transceiver Module
1. Make sure there is no network activity by consulting or checking with
the network administrator. Or through the management interface of
the switch/converter (if available) to disable the port in advance.
2. Remove the Fiber Optic Cable gently.
3. Turn the lever of the MGB/MFB module to a horizontal position.
4. Pull out the module gently through the lever.
1 2
MGB / MFB Series
Transceiver
Figure 3-2: Pulling Out from the Transceiver
Note
Never pull out the module without pulling the lever or
the push bolts on the module. Directly pulling out the
module with effort could damage the module and SFP
module slot of the Industrial Gigabit Media Converter.