PLANET ICA-HM120 - Manual (Page 10)

2.2.2 Rear View
2. Power Jack
1. Audio Output
5. RS-485 / DIDO
4. LAN Socket 3. Factory Reset Button
1. Audio Output Audio-out Jack allows this device to output audio for two-way
communication or alerting sound.
2. Power Jack The input power is 12VDC.
NOTE:
ONLY use package power adapter supplied with the internet. Otherwise,
the product may be damaged.
3. Factory Reset
Button This button is used to restore the all factory default settings. Sometimes
restarting the device will make the system back to a normal state.
However, if the system still got problems after restart, user can restore the
factory default settings and install it again.
Restore the device:
a. Insert the paper clip or other tool and press and hold the
button down continuously.
Hold it at least 8 seconds and release the tool. Then the device has been
restored to default settings and reboot again.
4. LAN Socket The LAN socket is a RJ-45 connector for connections to 10/100Base-TX
Fast Ethernet cabling. This Ethernet port built N-Way protocol can detect
or negotiate the transmission speed of the network automatically. Please
use CAT-5 cable to connect the IP camera to a 100Mbps Fast Ethernet
network switch or hub.
Power LED: (Orange)
This LED is used to indicate whether DC power is on or not.
LAN LED: (Green)
This LED will be flashing while network accessing via Ethernet.
9