ProSoft Technology MVI69-ADM - Manual (Page 94)

Programming the Module MVI-ADM ♦ 'C' Programmable
Developer's Guide 'C' Programmable Application Development Module
Page 94 of 342 ProSoft Technology, Inc.
February 20, 2013
SHELL=A:\TINYCMD.COM /s /p
If a command interpreter is not needed, the user application may be executed
directly from the CONFIG.SYS file as shown (where USERAPP.EXE is the user
application executable file name):
SHELL=A:\USERAPP.EXE
The user application may also be executed automatically from an
AUTOEXEC.BAT file, or manually from the console command line. In either
case, a command interpreter (page 94) must be loaded.
MVI56
IRQPRIORITY=1
INSTALL=A:\MVI56bp.exe
INSTALL=A:\MVI56dd.exe
MVI69
IRQPRIORITY=1
SYSTEMPOOL=16384
STACKS=5
SHELL=A:\TINYCMD.COM /s /p
INSTALL=A:\MVI69bp.exe
Note: At this time, messaging is not supported on the MVI69.
MVI71
IRQPRIORITY=1
INSTALL=A:\MVI71bp.exe
MVI94
IRQPRIORITY=1
INSTALL=A:\MVI94bp.exe
5.1.2 Command Interpreter
A command interpreter is needed if you want the module to boot to a command
prompt, or if you want to execute an AUTOEXEC.BAT file. Two command
interpreters are included, a full-featured COMMAND.COM, and the smaller, more
limited TINYCMD.COM. Refer to the General Software Embedded DOS 6-XL
Developer's Guide located on the MVI CD-ROM for more information.