ProSoft Technology MVI71-MNET - Manual (Page 13)

Start Here MVI71-MNET ♦ PLC Platform
User Manual Modbus TCP/IP Interface Module
ProSoft Technology, Inc.
Page 13 of 109
June 23, 2009
1 Turn power OFF.
2 Align the module with the top and bottom guides, and slide it into the rack
until the module is firmly against the backplane connector.
3 With a firm but steady push, snap the module into place.
4 Check that the holding clips on the top and bottom of the module are securely
in the locking holes of the rack.
5 Make a note of the slot location. You will need to identify the slot in which the
module is installed in order for the sample program to work correctly. Slot
numbers are identified on the green circuit board (backplane) of the PLC
rack.
6 Turn power ON.
Note: If you insert the module improperly, the system may stop working, or may behave
unpredictably.