Nikon D7200 body - Manual (Page 338)

314
1 Not available with spot metering.
2 Can also be selected with flash unit.
3 AA/A mode selection performed on flash unit using custom settings. Unless lens data have
been provided using the
Non-CPU lens data option in the setup menu, “A” will be
selected when a non-CPU lens is used.
4 Can only be selected with camera.
5 Available only during close-up photography.
6 Unless lens data have been provided using the Non-CPU lens data option in the setup
menu, non-TTL auto (A) is used with non-CPU lenses, regardless of mode selected with flash
unit.
7 Available only in i-TTL, AA, A, GN, and M flash-control modes.
8 Availalbe only in i-TTL, AA, and A flash-control modes.
9 Available only in commander mode.
10 Firmware updates for the SB-910 and SB-900 can be performed from the camera.
Auto FP High-Speed Sync 7 z z z z z z — —
FV lock 8 z z z z z z z z
AF-assist for multi-area AF z z z — z 9 — — —
Red-eye reduction z z z z — — z —
Camera modeling illumination
z z z z z z — —
Camera flash mode selection — — — z — — z z
Camera flash unit firmware update
z 10 z — z — — — z
A Using FV Lock with Optional Flash Units
FV lock ( 0 153) is available with optional flash units in TTL and (where
supported) monitor pre-flash AA and monitor pre-flash A flash control
modes. Note that when Advanced Wireless Lighting is used to control
remote flash units, you will need to set the flash control mode for the
master or at least one remote group to TTL or AA.
SB-9
10, SB-9
00,
SB
-8
00
SB
-7
00
SB
-6
00
SB
-5
00
SU
-8
00
SB
-R
20
0
SB
-4
00
SB
-3
00