Sharp PN-H801 - Manual (Page 16)

16
E
Preparing the Remote Control Unit
Installing the batteries
1. Press the cover gently and slide it in the direction of the arrow.
2. See the instructions in the compartment and put in the supplied batteries (LR-6 (“AA” size) x 2) with their plus (+) and minus (-)
sides oriented correctly.
3. Close the cover.
TIPS
• When the batteries become exhausted, replace them with new (commercially available) batteries.
• The supplied batteries (LR-6 (“AA” size) x 2) may become exhausted quickly depending on how they are stored.
• If you will not be using the remote control for a long time, remove the batteries.
• Use manganese or alkaline batteries only.
Remote control operation range
Operation panel in
The remote control can be operated even when the operation panel is stored inside the monitor.
Point the remote control toward the remote control sensor on the bottom of the monitor (or the right side of the monitor if using
portrait orientation).
16.4 feet
(5m)
16.4 feet (5m)
45º
10º
10º
45º 10º
10º
16.4 feet (5m)
10º
10º
16.4 feet
(5m)
10º 10º
For the monitor in landscape orientation For the monitor in portrait orientation
Remote control
sensor
Remote control sensor
Operation panel out
Point the remote control toward the remote control sensor on the front of the monitor.
16.4 feet
(5m)
16.4 feet (5m)
16.4 feet (5m)
10º
10º10º
10º
16.4 feet
(5m)
10º
10º
10º 10º
For the monitor in landscape orientation For the monitor in portrait orientation
Remote control
sensor
Remote
control
sensor
TIPS
• Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a malfunction.
• Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.
• The remote control unit may not work properly if the remote control sensor is under direct sunlight or strong lighting.
• Objects between the remote control unit and the remote control sensor may prevent proper operation.
• Replace the batteries when they run low as this may shorten the remote control’s operation range.
• If a fluorescent light is illuminated near the remote control unit, it may interfere with proper operation.
• Do not use it with the remote control of other equipment such as air conditioner, stereo components, etc.