Epson Y465ss127mo - Manual (Page 169)

The following is a typical example of a software setup required for
proper operation of your cut sheet feeder. Not all software is set up the
same, so you may find that a bit of experimentation is required before
you find the best equivalent settings to use.
To maintain 54 printed lines per page make the following changes:
Continuous Cut sheet
form settings feeder settings
Page Length 66 61
Top Margin 6 4
Bottom Margin 6 3
Many word processors and other software give you two ways to change
these settings:
l
You can change the settings in each individual file you print.
l
Alternatively, you can change the program’s default settings so that
every time you use the program, these new settings are in effect.
If your program has additional features, such as headers and footers, you
have to compensate accordingly.
Adjusting the loading position
If necessary, you can adjust the loading position of the paper in bin
1
or
bin 2 with the micro-adjustment feature described in the section on
setting the loading position in Chapter 3.
The micro-adjustment feature sets a new loading position for as long as
the power remains on. If the power is turned off, the loading position is
returned to the factory setting.
Changing the loading position with the micro-adjustment feature may
affect the number of lines per page. You may need to change your
software settings again for this new page length.
7-16
Using Printer Options