Setting time code generator, P74 [setting time code generator] ) – JVC GY-HC900STU 2/3" HD Connected Cam Studio Camcorder (Body Only) User Manual
Page 74
Time Code Operation Mode
Select the time code operation using the [TC
GEN] switch.
Setting
Description
F-RUN
The time code operates in the run
mode at all times regardless of the
recording status.
It continues to run even when the
power of the camera recorder is
turned off.
Synchronizes with the external
time code when an external time
code generator is connected.
R-RUN
The time code operates in the run
mode during recording. It
continues to run in the order of the
recorded clips as long as the SD
card is not replaced. If the SD card
is removed and recording is made
on another card, time code will be
recorded on the new card from
where it was left off in the previous
card.
REGEN
The time code operates in the run
mode during recording. When the
SD card is replaced, the last time
code recorded on the card is read
and recorded on a new card so that
the time code continues in running
order.
Memo :
0
When [System]
B
[Record Set]
B
[Rec Mode] is
set to “Interval Rec”
1
or “Frame
Rec”
1
, and the [TC GEN] switch is set to
“F-RUN”, R-RUN mode is activated.
0
When [System]
B
[Record Set]
B
[Record
Format]
B
[System] is set to “High-
Speed”
2
, and the [TC GEN] switch is set
to “F-RUN”, R-RUN mode is activated.
Setting Time Code
Generator
Presetting the Time Code
Time code and user’s bit data generated from the
internal time code generator are recorded.
This section describes how to set [TC/UB]
B
[TC
Preset].
Memo :
0
When [System]
B
[Record Set]
B
[Record
Format]
B
[
W
Frame Rate] is set to “50p”, “50i”
or “25p”, setting for “Drop” will be disabled.
0
You can configure the setting without accessing
the [TC/UB] menu screen.
P76 [Setting Time Code without Opening
Required Settings Before Preset
.
PRESET
TC
F-RUN
R-RUN
REGEN
UB
GEN
DISPLAY
1
Set the [TC GEN] switch to “R-RUN” or “F-
RUN”.
0
[R-RUN]
Preset data in the time code generator
operates in run mode during recording mode.
Set this when recording continuous time
code in connecting frames.
0
[F-RUN]
Time code starts to operate in run mode from
the preset time in the time code generator.
74
Time Code and User’s Bit
Sh
ooting