Mouse switching, Hotkey switching, Rs-232 commands – ATEN 2-Port USB 3.0 4K DisplayPort Dual-Display KVMP Switch User Manual
Page 26: Hot plugging, Powering off and restarting, Mouse switching hotkey switching rs-232 commands, Hot plugging powering off and restarting
CS1942DP / CS1944DP User Manual
18
Mouse Switching
For mouse port selection: Double-click the scroll wheel of your USB mouse to
cycle through the ports.
Note:
1. Mouse switching is only supported by USB 3-key scroll wheel
mice.
2. Mouse switching is disabled by default. See
page 24, to enable mouse switching.
3. Mouse switching is only supported when Mouse Emulation is
enabled.
Hotkey Switching
For Hotkey port selection: All port switches from the keyboard begin by
pressing the Scroll Lock key twice. Regarding details of the Hotkey
parameters, see
RS-232 Commands
For RS-232 port selection: Enter the correct command and control to switch
port. Regarding details of the RS-232 command and control, please refer to the
CS1942DP-CS1944DP RS-232 Command User Manual
.
Hot Plugging
The CS1942DP / CS1944DP supports USB hot plugging – components can be
removed and added back into the installation by unplugging their cables from
the USB hub ports without the need to shut the unit down.
Powering Off and Restarting
If it becomes necessary to Power Off the CS1942DP / CS1944DP unit, before
starting it back up, you must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch’s power adapter cable.
3. Wait 10 seconds, then plug the switch’s power adapter cable back in.
4. Once the switch is powered up, power on the computers.