HP Z2 G9 Mini Workstation - Manual (Page 15)

To attach the computer to other mounting fixtures, follow the instructions included with the mounting fixture
to ensure that the computer is safely attached.
CAUTION: This computer supports the VESA® industry-standard 100 mm mounting holes. To attach a third-
party mounting solution to the computer, you need four M4 x 10mm screws. These screws should be
supplied in the third-party mounting solution kit. Do not use longer screws because they can damage the
computer. Verify that the manufacturer’s mounting solution complies with the VESA standard and is rated to
support the weight of the computer. For best performance, use the power and other cables provided with
the computer.
NOTE: This apparatus is intended to be supported by a UL or CSA-Listed wall mount bracket.
NOTE: If the computer is to be mounted horizontally, position the computer so that all cords and cables
hang straight down from the connectors.
1. Remove the rubber feet from the bottom of the computer to expose the VESA mounting holes. Store the
feet on the underside of the top cover.
2. To attach the computer to a swing arm (sold separately), insert four M4 x 10mm screws through the
holes on the swing arm plate and into the mounting holes on the computer.
Setup procedures
Read this section to learn how to set up your computer.
WARNING! To reduce the risk of electric shock:
● Plug the power cord into an AC outlet that is easily accessible at all times.
● If the power cord has a 3-pin attachment plug, plug the cord into a grounded (earthed) 3-pin outlet.
NOTE: If your computer has more than 1100 W power supply, it might require more than the typical office
power can supply and might require you to check your site infrastructure for wall connector compatibility.
For details, see the Site Preparation Guide at http://www.hp.com/support . Follow the instructions to find
your product, and then select Manuals.
To set up the computer:
1. Connect the monitor to the computer.
2. Plug the computer power cord and monitor power cord into an AC outlet.
3. Connect the mouse and keyboard to the computer.
4. Turn the computer on.
5. Connect a network cable to the network jack or set up a WLAN connection via a wireless router.
6. Connect other peripheral devices (such as a printer) according to the instructions included with the
device.
Adding monitors
This section describes how to add monitors to your computer.
Setup procedures 9