Canon RC-V100 Remote Controller - Manual (Page 15)

15
En
24 PRESET (preset white balance) button
Changes the white balance to the preset white balance or color temperature setting
that was selected on the camera.
While a preset white balance or the color temperature setting is selected, the button
will light up in orange.
• To fine-tune a preset white balance setting or set the color temperature
1. While the PRESET button is lit up in orange, press the Å button.
The button will light up in red.
2. Fine-tune the preset settings (-9 to +9) or set the desired color temperature with
the Up/Down buttons (navigation buttons).
3. Press the Å button again to set the selected value.
The Å button’s light will go out.
25 WHITE BALANCE R (R gain) dial
26 WHITE BALANCE B (B gain) dial
These dials adjust, respectively, the R gain and B gain of the white balance settings.
By default, the operating mode of the dials is set to relative mode (
A 19). You can
change the direction in which you need to turn each dial and its sensitivity to your
preference (
A 19).
NOTES
• Only one of the four buttons AWB, A, B and PRESET can be selected at the same time.
27 MASTER BLACK R dial
28 MASTER BLACK B dial
These dials adjust, respectively, the red and blue settings of the master black.
By default, the operating mode of the dials is set to relative mode (
A 19). You can
change the direction in which you need to turn each dial and its sensitivity to your
preference (
A 19).
Zoom and focus controls
29 FOCUS/ZOOM ACTIVE indicator
This indicator lights up in green when the key lock mode has been set so only the
zoom and focus controls of the remote controller are active.
NOTES
• Immediately after selecting the Only zoom/focus controls active mode, this indicator
may flash momentarily. During that time, the controls cannot be used; please wait
until the indicator lights up permanently to use the remote controller.
29
30
31
32