Hasselblad H1D - Manual (Page 183)

182 183 Hasselblad H1D
Warnings and Restrictions
• Read all instructions before attempting to use your new
equipment.
• If your equipment requires service, please contact your Hasselblad
dealer.
• Keep this and all electronic equipment out of children’s reach.
• Do not lift or hold your camera by the viewfinder, sensor or film
back.
• Do not attempt to open the sensor unit or Image Bank.
• Keep your H1D camera, Image Bank, and all other computer equip-
ment away from moisture. If it becomes wet, disconnect from
power and allow to dry before attempting to operate again.
• Always replace the protective covers on the H1D camera body,
sensor unit or film magazine when separated.
• Store your H1D camera and Image Bank away from heat and
moisture.
• Keep all wires connected to or from your H1D camera, Image Bank,
and computer out of the way where they will not be tripped over.
• Never cover the devices ventilation openings.
Using Flash Sync
The H1D “Flash Sync” connectors are specified for use with low volt-
age flash generators. Do not connect to older high voltage flash
units.
The H1D sensor unit complies to ISO-10330 which limits voltages to
24V and currents to 100mA.
External Power Supply
If you choose to power your system using an external power supply
use only a type approved by Hasselblad for use with the H1D. See
“Technical Specifications” for details
Lithium Battery
• If you choose to power your system with a battery, use only bat-
teries approved by Hasselblad for use with the H1D. See “Technical
Specifications” details.
• Never short-circuit the battery terminals.
• CAUTION! Risk of explosion if battery is replaced by an incorrect
type.
Hasselblad H1D