Hasselblad H1D - Manual (Page 93)

92 93 Hasselblad H1D
Film speed
Film length
Data
Frame counter
Hasselblad H1D
Films without a barcode must have their speed set manually. A manual setting must also be
made if you want to override the speed setting of a barcoded film.
To access Manual setting:
1) Ensure the LCD settings lock is in the unlocked position.
2) Press the button until a figure (or barcode symbol) appears together with ISO.
3) Press either the or the button to reach the required setting.
4) The new setting will be saved automatically after a time out of five seconds.
5) Return the LCD settings lock to the locked position.
!
If you use both standard and barcoded films (or overridden barcoded films), check that
you have changed the settings accordingly.
Film length/number of frames B
Both 120 and 220 films can be used. 120 film will produce 8 (for use with ‘half-length’ 120
films only) or 16 frames and 220 film will produce 32 frames.
If the film has a barcode, then film length setting (and film speed setting) is automatic. e
LCD will automatically show the barcode symbol and the appropriate film length. (Note that
film speed can be overridden with barcoded films, but not film length).
If, however, the film has no bar code then proceed as follows:
To access film type setting:
1) Ensure the magazine settings lock is in the unlocked position.
2) Press the button until the 120 or 220 symbol appears.
3) Press either the or the button to change the desired setting (not possible at barcode
setting).