HP 3150 EN - Manual (Page 111)

EN Internal assemblies 109
4 Pull the four (4) cables from the connectors (callout 1) aligned
vertically along the right side of the formatter board, and then
open the tie-wrap that holds all four cables to release the cables.
5 Remove the remaining screw from the formatter board (callout 2).
Figure 37. Formatter board removal (2 of 2)
6 Remove the formatter board by lifting it up and off the hooks.
CAUTION Placing the formatter board on a conductive surface can damage the
board. Place the formatter board on an ESD mat.
Note See Chapter 6, “Troubleshooting,” for information about how to
download the most recent firmware version and software program
versions from the HP website (http:/www.hp.com/cposupport/).
Updating the firmware and software at the same time ensures their
complete compatibility.
2
2 2
1