HP 3150 EN - Manual (Page 121)

EN Internal assemblies 119
Pressure roller
1 Remove all covers, the RFI shield, the printer door, the exit roller,
the delivery assembly, the fuser pressure plate, the front casing,
and the heating element.
2 Remove the pressure roller guide by lifting the edge (callout 1)
and then rolling it gently backward (callout 2).
Figure 47. Pressure roller guide removal
3 Lift the right end of the pressure roller up and out of the printer
chassis.
Note The right end of the pressure roller is greased.
4 The left side will follow easily with the pressure roller gear still
attached.
Note When reinstalling the pressure roller, apply a drop of pressure roller
grease to the grounding plate on the right end of the shaft. See Chapter
7, “Parts and diagrams,” for information about ordering pressure roller
grease.
2 2
2 1