HP 3150 EN - Manual (Page 48)

46 Installation and operation EN
No Memory for
Report
Erase/Print
Document There is not enough memory to print a
report because memory is being used to
store faxes that have been received to
memory.
There is not enough memory to print a
report because memory is being used to
store faxes set up to be sent at a future
time or to be polled.
Print faxes that have been received to
memory.
If you have several faxes set up to be
sent at a future time or to be polled, try
clearing these faxes using job status.
No Modem Installed There is a problem with the line interface
unit (LIU). Unplug the power cord from the power
source, wait 10 seconds, and replug in
the power cord.
Connect the product to a different power
source.
If the error persists, see Chapter 6,
“Troubleshooting.”
No Room in Fax Log The fax log was unable to print because of
an error; for example, the product is out of
paper. Solve the error condition so that the
product can print the fax log.
Not Enough Memory There is not enough memory to complete
the job indicated. Try again to send the job. If the error
persists, press and hold
S TOP /C LEAR for
seven seconds to reset the product.
Not Enough Memory
to Duplicate for
COPY The HP LaserJet 3100/3150 product does
not have enough memory to complete the
copy job. Divide the copy job into smaller sections
and then try again to copy.
Use the Document Assistant to
complete the copy job.
No Fax Pages in
Memory to Reprint The HP LaserJet 3100/3150 product
attempted to execute “Reprint Last Fax”
when nothing was in memory. Wait for a fax, then as soon as a fax is in
the memory, the HP LaserJet 3100/
3150 product will reprint the fax.
Nov-22-93 06:30 PM
(An incorrect date
appears.) The battery inside the HP LaserJet 3100/
3150 product has failed, causing all Menu
features to revert to the factory settings.
Settings that contained alphabetic and
numeric characters you entered, such as
header information and speed-dial names
and numbers, have been erased. The battery should be replaced. You can
continue to use the HP LaserJet 3100/
3150 product without replacing the
battery, but any information you enter
will be erased again if power is lost.
Table 9. Control panel messages
Message Cause Solution